Oki PACEMARK 4410 Maintenance Manual page 139

G Alarm lamp flashes. Message on the LCD "ERROR AUTOGAP"
Does the carriage run during initialization?
No Yes
• to G-1
• Does the platen normally move during initialization?
Yes No
• G-4 Is the connection properly made to the CN1 and the CN2 on the PRA board?
Yes
• Is the connection of cable properly made to the CN2 on the PMA board?
Yes
• Is the gear between the autogap motor and platen in normal state? Does it disengage?
Yes
• Can the printer recover after the autogap motor is replaced?
No
• Can the printer recover after the PDA board is replaced?
No
• G-3 Can the printer recover after the PMA board is replaced?
No
• Can the printer recover after the connection cable between the PMA board the CN2 and
PRA board the CN1 is replaced?
No
• Replace the PRA board.
• Is the connection of cables properly made to the CN1 and the CN3 on the PRA board, and the
CN1 on the PGA board?
Yes No
• Properly reconnect the cables.
• Is the connection of cables properly made to the CN2 and the CN8 on the PMA board?
Yes No
• Properly reconnect the cables.
G-2
40496501TH Rev.1
No
• Make a proper connection.
No
• Properly reconnect the cable.
No
• Reinstall the gear in place. If it is damaged, replace it.
• If the gear of the autogap motor is damaged, replace the whole autogap motor.
Yes
• End
Yes
• End
Yes
• End
Yes
• End
139