Oki PACEMARK 4410 Maintenance Manual page 86

Match the direction of projections
Match the position of marks
1. Matching the phase of pin tractors
Match the direction of pin wheel projections on right/left pin tractor to that of mark on the 2
a.
(rear tractor drive gear).
Match the direction of wheel projections on right/left pin tractor to that of mark on 4 (drive gear
b.
B), and install 2 (drive gear B) to 53 (rear drive shaft of the rear tractor Assy) at a position
where the directions of marks on 4 (drive gear B) and 2 (rear tractor drive gear) match.
40496501TH Rev.1
Wheel
Wheel
4
Rear tracor Assy Gears phase drawing
Open up the notch to 1mm and assemble it,
positioning the notch as shown in figure.
Rotated notch
8 Assembling friction piece
Pin wheel
45°
Notch is rotated by 45°
86