Oki PACEMARK 4410 Maintenance Manual page 90

Item No. Items
2 AG Plate Gap
AG Frame
Eccentric Collar
Carriage Frame
3 Auto Gap Correction
1
POWER
2
ALARM
3
ONLINE
RESET
1
40496501TH Rev.1
Standard Value
C=0.14±0.02mm
AG Plate
Mounting Screws
O N - L I N E E P S
5
F R O N T F E E D
MENU
6
STORE
GROUP ITEM OPTION
2 3 4
3Turn on the printer while pressing
Switches B and C.
1st = 0EH
2nd = 0DH
3rd = 0EH
AVE = 0EH
4The auto gap correction has completed
if "Av" is printed.
Illustration
1Insert the thickness gauge between
the AG frame and the AG plate to veri-
fy the gap value C is between 0.12 and
0.16 mm.
2If adjustment is required, screw down
the mounting screws and adjust the ec-
centric collar to make the protector gap
value C between 0.12 and 0.16 mm,
then fix the AG plate.
Notes:
After this Adjustment, the Auto Gap
Correction should be conducted (See
item 3)
1Set the continuous form (1P, 15 in.
wide and 55 Kg) at the printing valid po-
sition and also the ribbon cassette.
7
CONFIG
FF/LOAD
LF
PATH
MicroFeed MicroFeed
TOF
Up Down
9 0 A
SHIFT
8
2Turn off the printer, then power on
again while pressing Switches B and
C to conduct the auto correction. If the
auto gap operation has been repeated
3 times and "Av=
end of the auto gap correction.
3The auto correction value from 09 H
to 18 H is desirable. If any value other
than this is indicated, the AG plate gap
should be adjusted again. (See Item 2)
Notes:
a) In the following cases, this adjust-
ment should be implemented.
i)After the gap adjustment between the
AG frame and the AG plate;
ii)After replacing the control board. (not
required after CG/PROGROM, EE-
PROM replacement)
b) When the correction value "Av= " is
not between 09 and 18, "Warning" will
be indicated on the LCD panel. Press
Switch 1 to reset this warning.
c) The correction value "Av= " from
09 to 18 is desirable. If any value oth-
er than this is indicated, the gap bet-
ween the AG frame and the AG plate
should be adjusted again to the prop-
er range as described in Item 2.
Then, conduct this correction.
Adjustment Method
TEAR PARK
B C
" printed, it is the
90