Table of Contents
Advertisement
Divar - Easy | Installation Manual | Operating instructions
Viewing pictures
Monitor A is the main monitor. It shows full-screen, quad or multiscreen live or
playback camera pictures. Status messages, alarms, and video loss warnings are
also displayed on this monitor. When the menu system is activated it is
displayed on this monitor.
When an alarm is detected, the camera picture is displayed on monitor A.
When multiple alarms occur, camera pictures are displayed in quad or
multiscreen.
Viewing
The drawing shows all possible views for monitor A. Some multiscreen views
may have been disabled during set-up. The Divar model and the number of
connected cameras can also influence the multiscreen views available.
1
5
1
9
13
1
1
2
4
3
4
7
The quad mode can have 4 different quad screens that can be shown in
sequence to display 16 camera pictures.
Bosch Security Systems
4x4
4+3
2
3
4
1
2
3
6
7
8
4
5
10
11
12
6
7
14
15
16
3x3
2
3
5
6
8
9
Multiscreen
To view different multiscreen displays on monitor A:
1. Press the multiscreen key
.
> A multiscreen display of camera pictures appears on monitor A.
2. Press the multiscreen key
again to go to the next programmed
multiscreen view.
> If you continue to press the multiscreen key
enabled multiscreen views.
Full-screen
To view a full-screen shot of a camera:
1. Press a camera key.
> A full-screen shot of the camera you selected appears.
> The camera key of the selected camera lights (green).
2. Press the multiscreen key
to go back to your previous multiscreen view on
monitor A.
Sequence
To view a sequence of live camera pictures of several cameras:
1. Press the ALT key
and then the sequence key
> The
indicator lights.
> A sequence of camera pictures appears, each for a pre-programmed dwell time.
2. Press the ALT key
and then the sequence key
> Zooming, pressing the multiscreen key or selecting a single camera also stops
sequencing.
EN | 3-6
, the unit cycles through all
.
to stop sequencing.
Advertisement
Table of Contents
