38
en | Operating instructions
5.3
Viewing pictures
The unit has two monitor outputs, A and B. The way in which these monitors display pictures
depends on how the system is configured. When an alarm or motion input is detected, the
camera picture with the Alarm/Motion indicator can be displayed on monitor A, B, or both.
When multiple alarms or motion occur, camera pictures are combined in a multiscreen
window on monitor A, B, or both.
5.3.1
Monitor A
Monitor A is the main monitor. It shows full-screen, quad, or multiscreen live or playback
pictures of both analog and IP cameras. Status messages, alarms, motion, and video loss
warnings are also displayed on this monitor. When the menu system is activated it is
displayed on this monitor.
5.3.2
Monitor B
Monitor B displays full-screen, quad, or multiscreen live pictures of analog cameras.
Selecting a monitor to control
To control the display on monitor A:
1.
2.
To control the display on monitor B:
1.
2.
5.3.3
Viewing
The drawing shows all possible views for monitor A and B. Some multiscreen views may have
been disabled during set up. The Divar model and the number of connected cameras also
influence the available multiscreen views.
Figure 5.3 Divar XF supports single, quad, 3x3, and 4x4 screen viewing
The multiscreen modes can have different multiscreens that can be shown in sequence to
display all camera pictures.
F.01U.135.429 | 2.5 | 2009.08
Check that the
light on the front panel is lit.
If
is not lit, press the monitor
Check that the
light on the front panel is lit.
If
is not lit, press the monitor
Single
1
Quad
1
2
3
4
Installation manual
key.
key
4x4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
3x3
1
2
3
4
5
6
7
8
9
Divar XF
Bosch Security Systems