Wall Mounting; Connect The Switch To A Power Source - HP ProCurve 1600M Installation Manual

Wall Mounting

You can mount the switch on a wall as shown in the illustration below.
C a u t i o n
The switch should be mounted only to a wall or wood surface that is at least
1/2-inch plywood or its equivalent.
1.
2.
10 mm M4
screws

5. Connect the Switch to a Power Source

1.
2.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 10-mm M4 screws.
Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).
Plug the included power cord into the switch's power connector and into
a nearby AC power source.
Re-check the LEDs during self test. See "LED Behavior" on page 2-9.
Installing the Switch 1600M and 2424M
Installation Procedures
5/8-inch wood
screws
2-13