Install Switch Module (Optional) - HP ProCurve 1600M Installation Manual

Installing the Switch 1600M and 2424M
Installation Procedures
2. Install Switch Module
Install a switch module into the slot as shown in the illustration on the next
page. For installation details, see the instructions in the Installation Guide
that comes with the module.
The slot cover can be removed with either a flat-bladed or Torx T-10 screw-
driver. Keep the slot cover for future use.
N o t e s
2-6
Any of the supported switch modules can be installed in the slot in the
Switch 1600M and 2424M, except the Gigabit Stacking Module, which can
be installed only in the Switch 2424M.
The modules can be "hot swapped", installed when the switch is powered
on and normally will be immediately operational. But, if the new module
is replacing a module of a different type than what was previously installed
in the slot, the switch must be rebooted after the new module is installed.
See "Hot Swapping the Switch Module" on page 2-20.
The transceivers that provide the ports in the Gigabit Stacking Module
for the Switch 2424M are NOT hot swappable. See the HP ProCurve
Switch 2424M Gigabit Stacking Module Installation Guide or the HP
ProCurve Gigabit Transceivers Installation Guide for more informa-
tion.
Make sure the module is fully installed and that you screw in the
retaining screws to secure the module in place.
If you do not install a module in the slot, make sure that the slot cover
plate is still attached over the slot for safe operation and proper switch
cooling.
(optional)