then click "Remote Management." The following message will be
displayed on your Web browser:
Below are descriptions of each option:
Host Address (1): Input the IP address of the remote host for
Port (2):
Enabled (3):
When you finish the settings, click "Apply" and you'll see the
following message displayed on the Web browser:
Click "Continue" to save the settings and go back to the Web
management interface; click "Apply" to save the settings and restart
the router so the settings will take effect after it reboots.
1
which you want to initiate management access.
You can define the port number through which
the router should expect an incoming request. If
you're providing a Web service (default port
number is 80), you should try to use another
port number. You can use the default port
setting (8080), or something like 32245 or 1429
(any integer between 1 and 65534).
Select the field to start the configuration.
40
2
3