Chapter Ii: System And Network Setup; Network Connections; Connecting To The Router Via Web Browser - Intellinet 524803 User Manual

Chapter II: System and Network Setup

2-1 Network Connections

If needed, visit www.intellinet-network.com
compatible 3G USB modems.
1. Connect your 3G / 3.5G USB modem to the USB port on the top
panel of the router.
2. Connect your computer to the Ethernet port on the right side
panel of the router. NOTE: It's recommended that you use a
cable connection through the Ethernet port for the router's initial
configuration. The PWR/CHG LED should be lighted green and
the Ethernet LED should be on if the computer or other network
device connected to the router's Ethernet port is turned on and
connected properly.

2-2 Connecting to the Router via Web Browser

After the network connection is established, the next step is to set
up the router with proper network parameters so it can work
properly in your network environment.
Before you can connect to the router and start the configuration
procedures, your computer must be able to obtain an IP address
automatically (use dynamic IP address). If it's set to use a static IP
for a complete list of
8