Failover - Intellinet 524803 User Manual

Reset (10):
After you finish the settings, click "Apply" (11) and the following
message will be displayed on your Web browser:
Click "Continue" to go back and continue with the router setup
procedure, or click "Apply" to reboot the router so the settings will
take effect. (Wait for about 30 seconds while the router reboots.)
To reset all page settings to previously saved values, click "Cancel."

3-4 FailOver

WAN failure detection works by detecting the presence of traffic on
the 3G modem link. If the link is idle for too long, the router will
attempt to ping a target IP address. If the ping does not reply, the
router assumes the link is down and attempts to fail over to an
Ethernet WAN link.
You can also click "Reset" to unselect entries.
110
9
1
2
3
4
5
6
7
8