IBM IntelliStation M Pro 6220 User Manual page 61

9. Connect one end of the parallel IDE or serial ATA signal cable into the back of
the drive and the other end of the cable into the parallel IDE or serial ATA
connector on the system board. For the location of the parallel IDE or serial
ATA connectors, see "System-board internal connectors" on page 32
Note: Make sure to route the signal cable so that it does not block the airflow
to the rear of the drives or over the microprocessor.
10. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
11. If you have other options to install or remove, do so now.
12. Replace the cover and frame-support bracket. See "Replacing the cover" on
page 48 and "Removing and installing the support bracket" on page 33 for
details.
13. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Installing a drive in bay 2
Complete the following steps to install or replace a drive in bay 2:
1. Follow the instructions in "Preinstallation steps" on page 38.
2. Turn off the computer and attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the cover and frame-support bracket. See "Removing the cover" on
page 33 and "Removing and installing the support bracket" on page 33 for
details.
5. Disconnect power and signal cables to the drive.
Chapter 4. Installing options
39