IBM IntelliStation M Pro 6220 User Manual page 65

6. Remove the drive cage from the computer.
7. Slide the existing drive out of the drive bay. Remove the drive from the drive
tray by gently pulling both sides of the drive tray outward until the mounting
pins are disengaged from the holes on the drive; then, lift the drive out of the
drive tray.
8. Touch the static-protective package containing the new drive to any unpainted
metal surface on the computer; then, remove the drive from the package and
place it on a static-protective surface.
9. Set any jumpers or switches on the new drive according to the documentation
that comes with the drive.
10. Attach the new drive to the drive tray. Place the drive on the drive tray and
align the holes on the drive with the mounting pins on the drive tray. Gently
pull both sides of the drive tray outward and insert the mounting pins into the
holes on the drive.
11. Slide the drive into the drive bay until the drive snaps into place, and place the
drive cage back into the computer.
Important: The following illustration shows where the connectors on the
parallel IDE and serial ATA (SATA) drives should be located when you install
the drive in the drive tray.
Connectors
on IDE drive
Connectors on
Serial ATA drive
Chapter 4. Installing options
43