Reading Um Area Information; Setting Expansion Instructions - Omron SRM1(-V2) Operation Manual

Programming Console Operations

4-2-5 Reading UM Area Information

1, 2, 3...

4-2-6 Setting Expansion Instructions

1, 2, 3...
40
SHIFT
3. Press the SHIFT and then the 1 Key again to turn the buzzer back on.
SHIFT
This operation is used to display the status of settings in the User Memory (UM)
area, and its capacity.
RUN
OK OK
1. Press the CLR Key to bring up the initial display.
2. Press the FUN and VER Keys.
FUN VER
I/O command area size
User program area size
This operation is used to read and change the function codes assigned to certain
instructions.
Set the expansion instructions before inputting the program. The SRM1 will not
operate properly if the function codes in the program are assigned incorrectly.
When setting the expansion instructions, set the PC Setup's DM 6602 bits 8
through 11 to "1."
Two function codes cannot be assigned to a single instruction.
For the SRM1 expansion instruction default settings, refer to the
/CPM1/CPM1A/CPM2A/CPM2C/SRM1(-V2) Programming Manual (W353).
Read OK
Set No
1. Press the CLR Key to bring up the initial display.
2. Press the EXT Key to display the settings.
3. Use the Up and Down Arrow Keys to scroll through the function codes and
read their corresponding instructions.
↓
/
<MONITOR>
B
1
The buzzer will not sound
when "BZ" is not displayed.
<MONITOR>
B
1
MONITOR PROGRAM
OK
00000
CLR
CM
00
RUN MONITOR
OK
No
00000
CLR
INST TBL
EXT
FUN017:ASFT
INST TBL
↑
FUN061:INI
Section 4-2
BZ
LAD
04.1
PROGRAM
OK
OK
READ
READ