Care And Cleaning; Service Centre; Disposal Of The Appliance - AEG 49332I-MN User Manual

6
– do not put any objects directly on
the appliance floor and do not
cover it with aluminium foil;
– do not put hot water directly into
the appliance;
– do not keep moist dishes and food
in the appliance after you finish the
cooking.
• Do not apply pressure on the open
door.
• Do not put flammable materials in
the compartment below the oven.
Keep there only heat-resistant acces-
sories (if applicable).
• Do not cover oven steam outlets.
They are at the rear side of the top
surface (if applicable).
• Do not put anything on the hob that
is liable to melt.
• If there is a crack on the surface, dis-
connect the power supply. There is a
risk of electric shock.
• Do not put heat-conducting materi-
als (e.g. thin metal mesh or metal-
plated heat conductors) under the
cookware. Excessive heat reflection
can damage the cooking surface.
• If you have an implanted pacemaker,
you must keep your upper body a
minimum of 30 cm away from the in-
duction cooking zones while they op-
erate.
• Do not use the appliance during a
power cut.

CARE AND CLEANING

• Before maintenance, make sure that
the appliance is cold. There is a risk
of burns. There is a risk that the glass
panels can break.
• Keep the appliance clean at all times.
A build-up of fats or other foodstuff
can result in a fire.
• Regular cleaning prevents the surface
material from deteriorating.
• For your personal safety and the
safety of your property, only clean
the appliance with water and soap.
Do not use flammable products or
products that can cause corrosion.
• Do not clean the appliance with
steam cleaners, high-pressure clean-
ers, sharp objects, abrasive cleaning
agents, abrasive sponges and stain
removers.
• If you use an oven spray, follow the
instructions from the manufacturer.
Do not spray anything on the heating
elements and the thermostat sensor
(if applicable).
• Do not clean the glass door with
abrasive cleaning agents or metal
scraper. Heat resistant surface of the
inner glass can break and shatter.
• When the door glass panels are dam-
aged they become weak and can
break. You must replace them. Con-
tact the service centre.
• Be careful when you remove the door
from the appliance. The door is
heavy.
• Bulb lamps used in this appliance are
special lamps selected for household
appliances use only. They cannot be
used for the full or partial illumination
of a household room.
• If it becomes necessary to replace
the lamp use one of the same power
and specifically designed for house-
hold appliances only.
• Disconnect the appliance from the
power supply before the replace-
ment of the oven lamp. There is the
risk of electrical shock. Cool down
the appliance. There is a risk of
burns.
• Do not clean catalytic enamel.

SERVICE CENTRE

• Only an approved engineer can re-
pair or work on the appliance. Con-
tact an approved service centre.
• Use only original spare parts.

DISPOSAL OF THE APPLIANCE

• To prevent the risk of physical injury
or damage:
– Disconnect the appliance from the
power supply.