Memory Modules - IBM System x3850 X5 Installation And User Manual

6. Reinstall the power supply (see Installing a hot-swap power supply) and
7. (IBM Business Partners only) Restart the server. Confirm that it starts correctly
8. (IBM Business Partners only) Complete the additional steps in "Instructions for

Memory modules

The following notes describe the types of dual inline memory modules (DIMMs)
that the server supports and other information that you must consider when you
install DIMMs:
v To confirm that the server supports the memory modules that you are installing,
v All server model types support 1.5 V, and model types 7143 and 7191 also
v The server supports up to eight memory cards. Each memory card holds up to
v At least one memory card with one pair of DIMMs must be installed for the
v The Intel 7500 Scalable Memory Buffer and the Intel 7510 Scalable Memory
v The server supports an additional 512 GB of memory when the 32-DIMM
v When you install additional DIMMs on a memory card, be sure to install them
v The server supports memory sparing. Memory sparing reserves memory
v You do not have to save new configuration information to the IMM when you
64
IBM System x3850 X5 and x3950 X5 Types 7145, 7146, 7143, and 7191: Installation and User's Guide
Note: To remove an internal removable flash memory drive, push down on the
locking collar to unlock the drive before you remove the drive.
reconnect the power cable.
and recognizes the newly installed devices, and make sure that no error LEDs
are lit.
IBM Business Partners" on page 29.
see http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.
support 1.35 V, 240-pin, 2 GB PC3-10600 or 4 GB, 8 GB, and 16 GB PC3-8500
double data-rate (DDR) III, registered synchronous dynamic random-access
memory (SDRAM) with error correcting code (ECC) DIMMs. Model types 7145
and 7146 also support 1 GB DIMMs. These DIMMs must be compatible with the
latest PC3-10600 or PC3-8500 SDRAM Registered DIMM specifications.
eight DIMMs.
server to operate.
Buffer are not interchangeable and cannot be used in the same server. Check the
label on the top of the memory card and then see http://www-03.ibm.com/
systems/info/x86servers/serverproven/compat/us/ to verify that the memory
card you are installing is supported in the server.
optional IBM MAX5 for System x memory expansion module is attached to the
server. An additional 1 TB of memory is supported when 32 GB DIMMs are
available.
in pairs. The DIMMs in each pair must match each other.
capacity for failover in the event of a DIMM failure, and the reserved capacity is
subtracted from the total available memory. Memory sparing provides less
redundancy than memory mirroring does. If a predetermined threshold of
correctable errors is reached, the contents of the failing DIMM are copied to the
spare memory, and the failing DIMM or rank is disabled. To enable memory
sparing through the Setup utility, select System Settings > Memory. (Memory
sparing and memory mirroring cannot be used at the same time.)
install or remove DIMMs. The only exception is if you replace a DIMM that was
designated as disabled in the Setup utility Memory Settings menu. In this case,
you must re-enable the row in the Setup utility or reload the default memory
settings.