Completing The Installation; Connecting The Cables - IBM System x3850 X5 Installation And User Manual

Completing the installation

To complete the installation, complete the following steps:
1. If you removed the front bezel, slide the bezel onto the front of the server
2. If you removed the top-cover bracket, reinstall it. Slide the blue latches into the
3. Place the top cover over the top of the server.
4. Slide the top cover forward; then, press down on the cover handle until it
5. Connect the cables and power cords to the rear of the server. For more
6. Start the server. Confirm that it starts correctly and recognizes the newly
7. (IBM Business Partners only) Complete the additional steps in "Instructions for

Connecting the cables

Notes:
1. Be sure to turn off the server before you connect any cables to or disconnect
2. Detailed cabling information is available in the Rack Installation Instructions that
3. For additional cabling instructions, see the documentation that comes with the
The following illustration shows the locations of the input and output connectors
on the rear of the server.
chassis.
locked position.
clicks into place.
information, see "Connecting the cables."
installed devices, and make sure that no error LEDs are lit.
IBM Business Partners" on page 29.
any cables from the server.
came with your server or the Installation Instructions that came with any cable
kits.
optional devices. It might be easier for you to route any cables before you
install certain optional devices.
Chapter 2. Installing optional devices
79