Pptp Vpn Setup - ZyXEL Communications SBG3500-N000 User Manual

Chapter 21 PPTP VPN

21.3 PPTP VPN Setup

Use this screen to configure settings for a Point to Point Tunneling Protocol (PPTP) server.
Click VPN > PPTP VPN to open the Setup screen as shown next.
Figure 127 VPN > PPTP VPN > Setup
This screen contains the following fields:
Table 98 VPN > PPTP VPN > Setup
LABEL
PPTP Setup
Enable
Local WAN Interface
IP Address Pool
Access Group
(Optional)
276
DESCRIPTION
Use this field to turn the SBG3500-N'S PPTP VPN function on or off.
Select an interface from the drop-down list and its IP address will be shown. This is the
WAN interface upon which PPTP VPN listens to a client's connection request.
Enter the pool of IP addresses that the SBG3500-N uses to assign to the PPTP VPN
clients.
Note: This is with a 24-bit netmask and should not conflict with any configured WAN,
LAN, DMZ, WLAN, or L2TP VPN subnet even if they are not in use.
Specify up to 2 LAN groups (subnets) which a PPTP VPN client is allowed to access. If
none is specified, all LAN groups can be accessed. Enter the IP address and subnet
mask for the LAN group(s).
SBG3500-N000 User's Guide