Table of Contents
Advertisement
13.1 Overview
By default, the four LAN interfaces on the Device are in the same group and can communicate with
each other. Creating a new interface will create a new LAN bridge interface (subnet) (for example,
192.168.2.0/24) that acts as a dependent LAN network, and is a different subnet from default LAN
subnet (192.168.1.0/24).
13.2 The Interface Group/VLAN Screen
You can manually add a LAN interface to a new group. Alternatively, you can have the Device
automatically add the incoming traffic and the LAN interface on which traffic is received to an
interface group when its DHCP Vendor ID option information matches one listed for the interface
group.
Use the LAN screen to configure the private IP addresses the DHCP server on the Device assigns to
the clients in the default and/or user-defined groups. If you set the Device to assign IP addresses
based on the client's DHCP Vendor ID option information, you must enable DHCP server and
configure LAN TCP/IP settings for both the default and user-defined groups. See
161
for more information.
Use the Interface Group/VLAN screen to create a new interface group, which is a new LAN bridge
interface (subnet). Click Network Setting > Interface Group/VLAN to open the following
screen.
Figure 92 Network Setting > Interface Group/VLAN
The following table describes the fields in this screen.
Table 68 Network Setting > Interface Group/VLAN
LABEL
Add New
Interface Group
Status
SBG3500-N000 User's Guide
DESCRIPTION
Click this button to create a new interface group.
This field displays whether the interface group is active or not. A yellow bulb signifies that
this group is active. A gray bulb signifies that the group is not active.
C
HAPTER
Interface Group
1 3
Chapter 8 on page
226
Advertisement
Table of Contents
Troubleshooting
