No Security; Basic (Wep Encryption) - ZyXEL Communications SBG3500-N000 User Manual

Chapter 7 Wireless
Table 19 Network Setting > Wireless > General (continued)
LABEL
Apply
Cancel

7.2.1 No Security

Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
Note: If you do not enable any wireless security on your Device, your network is
accessible to any wireless networking device that is within range.
Figure 35 Wireless > General: No Security
The following table describes the labels in this screen.
Table 20 Wireless > General: No Security
LABEL
Security Level

7.2.2 Basic (WEP Encryption)

WEP encryption scrambles the data transmitted between the wireless stations and the access points
(AP) to keep network communications private. Both the wireless stations and the access points
must use the same WEP key.
Note: WEP is extremely insecure. Its encryption can be broken by an attacker, using
widely-available software. It is strongly recommended that you use a more
effective security mechanism. Use the strongest security mechanism that all the
wireless devices in your network support. For example, use WPA-PSK or WPA2-PSK
if all your wireless devices support it, or use WPA or WPA2 if your wireless devices
support it and you have a RADIUS server. If your wireless devices support nothing
stronger than WEP, use the highest encryption level available.
Your Device allows you to configure up to four 64-bit or 128-bit WEP keys but only one key can be
enabled at any one time.
136
DESCRIPTION
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
DESCRIPTION
Choose No Security to allow all wireless connections without data encryption or
authentication.
SBG3500-N000 User's Guide