Integrated Peripherals - CHAINTECH 5TDM2 Manual

3-7 Integrated Peripherals

This section provides information on setting peripheral devices. By choosing the
Integrated Peripherals option from the CMOS Setup Utility menu (Figure 4-1), the
screen below is displayed. This sample screen contains the manufacturer's default
values for the mainboard.
IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA : Auto
IDE Secondary Slave UDMA
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
Onboard FDC Controller
FDC Write Protect
PS/2 mouse function
Onboard Serial Port 1
Onboard Serial Port 2
COM2 Mode
A. On Board IDE Control
IDE HDD Block Mode
Specifies the maximum number of sectors that can be transferred at a time.
On-chip Primary/Secondary PCI IDE
You can set this to disable the On-chip IDE controller if you are going to add
a higher performance IDE board.
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (programmed Input/Output) fields let you set a PIO mode (0-
4) for each IDE device that the internal PCI IDE interface supports. Modes 0
through 4 provide successively increased performance. In Auto mode, the system
automatically determines the best mode for each device.
B. COM2 Mode
When this function is Enabled, then the COM port will be redirected to support
IR function.
ROM PCI / ISA BIOS (2A59IC3E)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
: Enabled
: Auto
: Auto
: Auto
: Auto
: Auto
: Auto
: Auto
: Enabled
: Enabled
: Enabled
: Disabled
: Enabled
: 3F8/IRQ4
: 2F8/IRQ3
: Standard
Figure 3-8 Integrated Peripherals Setup Screen
Award BIOS Setup Program
Onboard Parallel Port
Parallel Port Mode
USB Keyboard Support
ESC : Quit
F1 : Help
F5 : Old Values
F7 : Load Setup Defaults
: 378/IRQ7
: SPP
: Disabled
:Select Item
PU/PD/+/- : Modify
(Shift) F2 : Color
37