Time Zone And Dst - D-Link xStack User Manual

xStack
Parameter
System Boot Time
Current Time
Time Source
SNTP State
SNTP Primary Server
SNTP Secondary Server
SNTP Poll Interval in
Seconds (30-99999)
Year
Month
Day
Time in HH MM SS
Click Apply to implement your changes.

Time Zone and DST

The following window is used to configure time
zone and daylight savings time settings for SNTP.
To view this window, click Administration >
SNTP Settings > Time Zone and DST, as shown
on the right:
The following parameters can be set:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Description
Displays the time when the Switch was initially started for this session.
Displays the Current Time.
Displays the time source for the system.
Current Time: SNTP Settings
Use this pull-down menu to Enabled or Disabled SNTP.
The IP address of the primary server from which the SNTP information will be taken.
The IP address of the secondary server from which the SNTP information will be taken.
The interval, in seconds, between requests for updated SNTP information.
Current Time: Set Current Time
Enter the current year, to update the system clock.
Enter the current month, to update the system clock.
Enter the current day, to update the system clock.
Enter the current time in hours, minutes, and seconds.
Current Time: Status
Figure 2 - 31 Time Zone and DST Settings window
36