Multicast Forwarding - D-Link xStack User Manual

xStack

Multicast Forwarding

The following window describes how to set up Multicast Forwarding on the Switch.
To view this window, click, L2 Features > Forwarding & Filtering >Multicast Forwarding, as shown below:
The Static Multicast Forwarding Settings window displays all of the entries made into the Switch's static multicast forwarding
table. Click the Add button to open the Setup Static Multicast Forwarding Table window, as shown below:
Figure 3 - 56 Setup Static Multicast Forwarding Table window
The following parameters can be set:
Parameter
Unit
VID
Multicast MAC
Address
Port Settings
Click Apply to implement the changes made. To delete an entry in the Static Multicast Forwarding Table, click the corresponding
under the Delete heading. Click the
Settings window.
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 3 - 55 Static Multicast Forwarding Settings window
Description
Select the switch in the switch stack to be modified.
The VLAN ID of the VLAN the corresponding MAC address belongs to.
The MAC address of the static source of multicast packets. This must be a multicast MAC
address.
Allows the selection of ports that will be members of the static multicast group and ports that
are either forbidden from joining dynamically, or that can join the multicast group dynamically,
using GMRP. The options are:
None – No restrictions on the port dynamically joining the multicast group. When None is
chosen, the port will not be a member of the Static Multicast Group.
Egress – The port is a static member of the multicast group.
Show All Multicast Forwarding Entries link to return to the Static Multicast Forwarding
154