Limited Ip Multicast (Igmp Filtering) Address Range Settings - D-Link xStack User Manual

xStack
2 and 4094.
State Use the pull-down menu to enable or disable the selected Multicast VLAN.
Enter a port or list of ports to be added to the Multicast VLAN. Member ports will become the
Member Port
untagged members of the multicast VLAN.
Tagged Member Enter a port or list of ports to be added to the Multicast VLAN as a tagged member port.
Port
Source Port Enter a port or list of ports to be added to the Multicast VLAN. Source ports will become the
tagged members of the multicast VLAN.
Replace Source This field is used to replace the source IP address of incoming packets sent by the host before
IP being forwarded to the source port.
Click Apply to implement settings made.
To configure the new Multicast VLAN Group List, click the corresponding Modify button in the IGMP Snooping Multicast
VLAN Table which will reveal the following window to be configured.
Figure 3 - 35 IGMP Snooping Multicast VLAN Group List Settings
Enter an existing VLAN Name and range and click Add. To remove all entries click the Remove All button.

Limited IP Multicast (IGMP Filtering) Address Range Settings

This window allows the user to specify which multicast address(es) reports are to be received on specified ports on the Switch.
This function, also known as IGMP Filtering, will therefore limit the number of reports received and the number of multicast
groups configured on the Switch. The user may set an IP address or range of IP addresses to accept reports (Permit) or deny
reports (Deny) coming into the specified switch ports.
To view this window, click L2 Features > IGMP Snooping > Limited Multicast Address Range Settings as shown below:
To configure Limited IP Multicast Range:
Choose the port or sequential range of ports using the From/To port pull-down menus.
Use the remaining pull-down menus to configure the parameters described below:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
134