White Balance - Honeywell HD3HDIH User Manual

HD3 equIP
Setting Options
Day/Night Auto, Day, Night,
Alarm Input
Night Mode B/W or Color
Detect Time 5–60 seconds
WDR (Wide Dynamic Off, Low, Medium,
Range) High
(HD3MWIH(X) only)
LDC (Lens Distortion Off, On
Correction)
(HD3MWIH(X) only)
DayToNight 1–7
NightToDay 3–9

White Balance

Document 800-07361V5 Rev A
07/2013
®
Series H.264 Indoor High Resolution True Day/Night IP Dome Camera User Guide
Table 4-10 Auto Exposure Settings (cont'd)
Description
Controls True Day/Night (TDN) operation. When Auto is selected, the
IR-cut filter will be removed automatically in low-light scenes. When Day
is selected, the IR-cut filter is on at all times. When Night is selected, the
IR-cut filter is off (removed) at all times.
When Alarm Input is selected, the IR-cut filter will be interlocked with
Alarm Input. It will be automatically enabled if D/N control is selected for
Night Mode on Alarm in the I/O & Audio tab. See
Day/Night Switching
Sets the color mode as B/W (monochrome) or Color in Night Mode.
Day/Night must be set to Night.
Sets the time (5–60 seconds) before the camera switches to Day or
Night mode after detecting a low-light condition or a normal light
condition, respectively.
Day/Night must be set to Auto.
Wide dynamic range provides clear, balanced images in high-contrast
lighting conditions. Set the WDR to Off, Low, Medium, or High.
When On, LDC reduces picture distortion. The performance of Frame
Rate mode might be impacted by LDC.
Determines the low light detection level (1–7) when the camera
switches to Night mode. The lower the value, the darker the lighting
conditions before the camera switches.
Day/Night must be set to Auto.
Note The DayToNight threshold level must be set at least 2 less than
the NightToDay threshold setting.
Note The DayToNight threshold range is decreased if the AGC level is
reduced.
Determines the low light detection level (3–9) when the camera
switches to Day mode. The higher the value, the brighter the lighting
conditions before the camera switches.
Day/Night must be set to Auto.
Note The NightToDay threshold range is decreased if the AGC level is
reduced.
White Balance ensures that color integrity is maintained in the camera image by
compensating for the temperature color "casts" that different light sources can cause. Use
Table 4-11 to set up White Balance options.
on page 88.
Alarm Interlock
75