Adjusting The Lens Focus; Figure 2-9 Gimbal Adjustment - Honeywell HD4DIP Reference Manual

Installation and Setup
Top view
Setscrew (loosen to
adjust horizontal
rotation)
Set focal length
(bottom)
Set focus
(top)

Adjusting the Lens Focus

TECH TIP!
28
Figure 2-9 Gimbal Adjustment
Loosen locking screw (inside
conduit entry) to remove the
side conduit plug.
Lenses are pre-focused at the factory. They may require a final adjustment after installation
in the unlikely event the optical effect of the dome camera causes a slight defocusing of the
lens.
To check the focus, hold the dome over the lens while making any adjustments.
To adjust the camera direction, view angle and focus, connect the service monitor cable
(supplied) to the video monitor output.
Angle view
B
C
A
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation