Table of Contents
Advertisement
A/V export
In the A/V export tab, you can enter information for sending e-mail or FTP
uploading in an alarm scenario.
In order to export videos or single images, adjust the following settings:
1. Activate the Display camera name and time checkbox to display the
camera name and the time in the exported data.
2. Optional: Activate the Reduce resolution checkbox to reduce the resolution
of the video.
3. Optional: Activate the Maximum length (s) checkbox to limit the export
time range.
Video settings
1. Select or deselect export with reduced frame rate.
This option only applies for MPEG-4/H.264 recordings. If the Reduce frame rate
option is activated, only the I-frames of the image recording will be exported.
Motion JPEG recordings are always exported with full frame rate.
Single image sequences
1. Select or deselect frame rate reduction and enter the frame rate in the
Maximum frame rate (fps) field.
2. Select whether single images should be sent in a ZIP folder.
SeeTec motion detection
If the camera does not provide integrated motion detection functions, you can
activate SeeTec motion detection. However, we recommend using the camera
motion detection whenever possible in order to keep the system load of the SeeTec
servers to a minimum.
1. To enable motion detection, click on Edit to determine the number of areas
to be monitored.
Different areas are required if various alarm scenarios are to be triggered for each
individual area.
2. Enter an area name in the Name field.
3. Enter the dead time of the area in the Dead time (s) field.
The dead time is the time at which no other incoming signal is accepted after the
first incoming signal.
4. Use the mouse to highlight the area of the camera image for motion
detection (left mouse button to select, right mouse button to cancel the
selection).
NVR Software - SeeTec Surveillance
85
Advertisement
Table of Contents
