Table of Contents
Advertisement
3.9
Access data
By default, the SeeTec 5 software features an administrator user who will have full
access to the entire system.
Starting SeeTec Surveillance
1. In the start menu under All Programs > SeeTec > SeeTec 5, click on SeeTec
Surveillance.
2. In the User name field, enter the following user name: administrator.
User name can also be optionally saved.
3. In the Password field, enter the following password: pass.
4. Optional: Save the password.
5. Optional: Enter a comment in the Comment field.
The comment will be stored in the management database. You can display the
comment in Report Mode when searching for user events.
6. Optional: Activate the Log in user automatically option.
You will immediately be logged on to SeeTec 5 when SeeTec Surveillance is
started again.
7. Click on OK.
Important
Change your password immediately after starting the system for the
first time in order to avoid unauthorized access to the software. A
secure password (optional) is at least 8 characters long and contains
at least one upper, one lower case character and one number.
All user names and passwords are CASE-SENSITIVE, i.e. a
distinction will be made between upper and lower case letters.
There is no "back door" to the SeeTec 5 system.
If you forget the administrator password and you have no user
assigned to the administrator group, you will be unable to access
the system.
While logging in via NAT, you must activate the option Use NAT for
server selection.
You must deactivate this option to login without NAT, see chapter
NAT list (page 129).
NVR Software - Installation
39
Advertisement
Table of Contents
