Table of Contents
Advertisement
NVR Software - SeeTec Surveillance
Start (Expert Mode)
The expert mode is only available with the appropriate license. This mode allows
the configuration of complex alarm scenarios. An alarm is triggered under various
conditions that can be combined using the logical operands AND or OR.
1. Optional: Specify a precondition that must be met before an alarm can be
triggered by certain events. Select the input(s) that will be closed or opened,
so that the alarm can be triggered with the Edit button in the Input trigger
conditions for alarms field.
The operand in this field is AND. If an input is disabled, but it is still listed in this
field, then this condition is recognized as true and alarm is triggered.
2. In the Seconds field, specify the duration in which the following events must
occur to trigger an alarm.
Within the fields, an OR link is created; between the fields an AND link is
established.
3. With the Edit button, select the events in the group fields that will trigger
the alarm (digital inputs closed / opened, SeeTec Network I/O inputs).
Alarms can be triggered via buttons as well. To start an alarm scenario via a
button, configure it in the tab with the same name. These buttons will then be
listed in the lower Buttons that trigger the alarm field.
End
Preliminary exit of an alarm scenario can either take place via option information
Maximum server alarm duration (s) (= Recording duration of alarm) or via
further triggers (digital inputs, activation via Edit button).
You can also terminate an alarm by using a Button. This button must be defined at
a later point of time using the Buttons menu option.
114
Note
Depending upon the camera model used, two events can be used
each as triggers for an alarm scenario:
Manipulation: The camera angle is changed or the objective
of the camera is covered.
Video loss: Connection between analog camera and video
server is lost.
Advertisement
Table of Contents
