Configure A/V Export; Enter A Port; Using A Primary Or Secondary Ftp Server; Select Codec - SUPERLOLUX NI525A User Manual

6.5

Configure A/V export

To send single images or video sequences in an alarm scenario via e-mail or FTP,
enter the required information under A/V export.
Important
Specify the single image and video options in the Camera
configuration and in the alarm scenario.
Start the SeeTec5_AVExport service on the core server,
otherwise, there will be no export.
6.5.1

Enter a port

1. Enter the Port used by the A/V export module (default: 64222).
6.5.2

Using a primary or secondary FTP server

1. In the Primary FTP server group box, enter the server address and the
port of the FTP server as well as the user name and password for FTP server
access.
Optionally, the export may be transferred to the FTP server with SSL encryption.
The secondary FTP server is optional. The secondary FTP server is used only when
the primary FTP server is not available.
6.5.3

Select codec

1. Select the Codec that will be used for the exported video sequence.
The codec must be locally available. Otherwise, it is not available for selection.
Note
If possible, do not use any Codecs installed by default by Windows
These codecs lead to low-quality export results.
If different frame rates and resolutions are present in the time
range to be exported (e.g. after a change from standard to alarm
recording) you should check the film sequence because the selected
codec may show a contorted image from the time of change
onwards.
SeeTec recommends the Xvid codec.
NVR Software - SeeTec Administration
®
.
173