Table of Contents
Advertisement
6
NVR Software - SeeTec Administration
The SeeTec Administration is used to set the core services, the management
database (MaxDB), the MultimediaDatabase and the A/V export.
Use the File menu to adjust the language of the SeeTec Administration and to save
changes in the currently open tab or in all tabs.
Important
All settings will only be adopted when rebooting all services and/or
the computer.
6.1
General settings
1. In the General settings, you can change the host and the port in the Host
and Port fields, if the SeeTec Administration was called on a secondary
server.
2. In the Host field, enter the IP address of the core server.
Leave the value in the port field unchanged (default: 60000).
Do not change these settings if the SeeTec Administration was called on the core
server. (default: Host: localhost, Port: 60000).
3. In the IP address/host name for server communication dialog, select
the IP address that the SeeTec services will connect to.
6.2
Configure core services
To ensure communication between individual services, each SeeTec service must be
assigned a unique port.
The ports listed here are of special importance when setting up firewalls, see
chapter Firewalls and SeeTec 5 (page 177).
Do not change the ports.
6.3
Configure management database (MaxDB)
The Management Database (MaxDB) tab helps you to manage the MaxDB. The
management database contains the entire SeeTec configuration and all events that
occurred. The recorded image data is saved in the MultimediaDatabase.
NVR Software - SeeTec Administration
167
Advertisement
Table of Contents
