Table of Contents
Advertisement
NVR Software - SeeTec Surveillance
5. Use the Start test and Stop test buttons to check your settings.
All amplitudes above the threshold line in the test field are recognized as motion.
6. To precisely set motion detection sensitivity, move this line up or down.
Motion detection of the server
1. Activate the motion detection.
2. Optional: In the Video analysis module field, select the video analysis
module that is to be used for motion detection.
3. Only with multi-streaming enabled:
Select the profile in the Profile dropdown list.
4. In the Areas field, enter a name for the area that is to be created.
5. Click on the + button to create the area.
6. Click on the camera image to create a vertex for the area of the motion
detection.
7. With every further click, you create another vertex.
86
Important
The SeeTec motion detection feature can only be enabled and
configured if the camera delivers single frames, i.e. if the
Streaming mode Motion JPEG is selected in the General dialog
of the Camera configuration screen.
The motion detection feature only delivers suitable results for
motion detection in internal spaces.
For each active motion detection process, approx. 400 MHz of CPU
power are required on the SeeTec server.
Because the mapping of SeeTec motion detection to the video
stream is not unique when multi-streaming is enabled, the following
applies:
When multiple profiles use JPEG and are permanently active,
one of these is selected for motion detection.
If there is no additional profile, the basic profile is used,
provided it uses JPEG.
Note
Use the motion detection of the server only if the camera does not
have integrated motion detection.
Advertisement
Table of Contents
