Table of Contents
Advertisement
3. Define the maximum Bandwidth that is to be provided for the camera to
SeeTec server connection.
By default, the image stream is compressed to 4096 kbit/s.
Different settings for Standard recording and Alarm recording during MPEG-4 /
H.264 streaming can result in a several seconds delay when switching from
standard to alarm recording (this is camera-dependent). No recording takes place
during this period.
4. Change the settings for alarm recording only if you explicitly require a
different resolution or bit rate in case of an alarm and the loss of recorded
time is negligible.
Important
MPEG-4 / H.264 streaming is manufacturer-specific and is not
supported by all cameras.
The frame rate is not indicated on Panasonic cameras. To limit the
image stream, change the bandwidth setting in Camera
configuration > Image storage.
For a client side display of MPEG / H.264 streaming, the screen
saver must be disabled.
Always keep the video card drivers updated that are installed on the
client.
If the alarm recording values specified for Resolution,
Compression, I-Frame distance or Bandwidth are different from
those of standard recording, then videostreaming must be re-
started. This can lead to a recording outage of at least one I-Frame
distance.
NVR Software - SeeTec Surveillance
79
Advertisement
Table of Contents
