Saving Or Loading The User Interface - SUPERLOLUX NI525A User Manual

Note
If an alarm scenario is triggered, the layer change will be stopped
automatically. After termination of the alarm scenario you need to
restart the layer change manually.
Right-click to close the current layer or all open layers in the current
window. This is only applicable for Layers that are not permanently
allocated to the user.
5.3.12

Saving or loading the user interface

To ensure that the user interface, i.e. the positions of all tool bars, remains
available, you can locally save the user interface layout. In addition, the current
interface layout is always saved when terminating SeeTec Surveillance.
Saving the user interface locally
1. In the main menu, click on View.
2. Select Save user interface or press CTRL + S.
Note
This layout only applies to the user that is currently logged in.
Temporary layers are not saved.
Restoring a saved user interface layout
1. In the main menu, click on View.
2. Select Load user interface or press CTRL + O.
Note
The user interface layout is saved upon termination of the software.
The most recently used layout is displayed when starting the
software again.
NVR Software - SeeTec Surveillance
149