Table of Contents
Advertisement
NAT list
To access SeeTec 5 via the internet without using a VPN tunnel, you first need to
enable the port forwarding feature on your router and/or your firewall. The default
ports required for this are 60000 – 60008 (TCP).
General
Address translation
1. Enter the internal IP address of the SeeTec server in the Internal
computer name field as well as the respective port in the Internal port
field.
2. In the Public computer name and Public port fields, enter the respective
IP address and port you set for port forwarding, e.g.
Internal computer name
192.168.0.1
Public computer name
111.111.111.111
3. Then, click on Add new entry.
4. Repeat this step until you have integrated all ports.
5. To delete an entry, select it and click on Remove selected entry.
If encrypted communication is enabled (see chapter Installation (page 27)), you
need to enable port forwarding for port 60011 and 60012, as well.
Important
When logging in via NAT, the Use NAT translation option must be
enabled during server selection.
When logging in without NAT, this option must be disabled before
login.
When you want to communicate to a distributed installation via NAT,
then you must also create inputs for ports used (60006 and 60008)
on the distributed servers.
6. To delete an entry, select it and click on Remove selected entry.
EBÜS interface
In the EBÜS interface you can configure the interface between SeeTec and EBÜS
(consistent image transmission system, producer: Accellence Technologies GmbH).
For further information, see the EBÜS interface manual.
NVR Software - SeeTec Surveillance
Internal port
60000
Public port
64000
129
Advertisement
Table of Contents
