Table of Contents
Advertisement
2.
Configure the LAN IP Address of Access Point 2. In this example, it is set to the default address of 192.168.1.2:
3.
Set the DHCP Server on Access Point 2 to Disable:
4.
Under Wireless Setup, select the same frequency channel as you did for Access Point 1. Enter an SSID to identify Access
Point 2. Copy the Network Authentication and Encryption settings from Access Point 1. Set Access Point 2 to Repeater
mode and enter the MAC address of Access Point 1 in the AP MAC Address1 field. The MAC address of Access Point 1 is
listed on the same page under Wireless Settings > Basic under the Wireless Distribution System (WDS) section. When you
have entered the required information, click Save:
www.netcommwireless.com
Figure 40 - WDS - Access Point 2 LAN IP Setup
Figure 41 - WDS - Access Point 2 DHCP Settings
NetComm Wireless NTC-30WV 3G Outdoor Router with Voice /
43
Advertisement
Table of Contents
