Table of Contents
Advertisement
Installation Procedure
DHCP Phone Installation
1. Connect the longer LAN cable from the network LAN socket to the power
3. Connect the shorter LAN cable supplied with the IP telephone from the
4. The phone's message indicator should glow red for a few seconds. The
5. After a short delay the phone should display Initializing and then
6. The phone displays DHCP and a timer. After a few seconds it should
7. The phone requests the 46xxupgrade.scr file from the TFTP server
8. The phone now requests additional files according to the instructions it
9. Following file loading the phone displays Ext. =. Enter the extension
10. The phone displays Password =. Enter the password and press #.
11. The phone will briefly display the time and date and then its extension
12. Test that you can make and receive calls at the extension.
13. Using Manager, you can now open the Control Unit's configuration and alter
INDeX 4602 IP Telephone Installation Manual
38DHB0002UKCQ – Issue 2 (11/06/2003)
unit's LINE socket.
Note:
The 400B2 Power Adaptor used for providing power for 4602 IP
Telephones is not compatible with the sockets on INDeX units. We
therefore advise against the direct connection of these adaptors.
Power Unit's PHONE socket to the socket with a LAN port symbol () at the
back of the IP telephone.
phone will then begin its software loading.
Loading.... The loading phase may take a few minutes.
•
If the phone displays No Ethernet check the connection to the LAN.
complete DHCP negotiation with the Control Unit. If the timer reaches more
than 60 seconds then you should suspect a error in either network or DHCP
operation.
(Manager). This should be visible in the Manager's TFTP Log.
found in the 46xxupgrade.scr file. The phone will go through a cycle of
requesting files, loading files and then transferring the files into its flash
memory.
number you want applied to the phone and press #.
•
Wrong Set Type is displayed if you try to use the extension number of
an existing non-IP extension.
number.
the extension and user settings as required:
•
In the list of extensions, the icon indicates VoIP extensions. A new
extension will have been created matching the extension number
entered above. In the extension's VoIP tab, the Compression Mode
default is Automatic Selection. If this needs to be changed select
G.729(a) 8K CS-ACELP.
•
In the list of users, a new user will have been created matching the
extension number entered above.
IPNC Setup - Page 7
Installation Procedure - Page 7
IPNC Setup
Advertisement
Table of Contents
