Anamorphic Lens Installation And Adjustment - Standard Rs-1100/Cinewide Or Rs-1100 Ultra/Cinewide; Standard Rs-1100 Anamorphic Lens Mounting Assembly - Exploded View - Runco RS-1100 CineWide Owner's Operating Manual

Installation
Anamorphic Lens
Installation and
Adjustment - Standard
RS-1100/CineWide or
RS-1100 Ultra/CineWide
Focus: Finally, rotate the Focus Ring on the anamorphic
lens to fine-tune the optical focus.
Standard RS-1100/CineWide (Prismatic Lens): The standard RS-1100 Anamorphic
lens mount kit consists of everything shown in Figure 3-18. Some components shipped
with your projector may differ slightly from what is shown in these instructions.
Figure 3-18. Standard RS-1100 Anamorphic Lens Mounting Assembly - Exploded
View
1. Use the Pitch Adjustment Screws
(item #3) and Washers (item #6) to
attach the Mounting Brackets (item
#2) to the Anamorphic Lens (item
#1).
2. Use the four Y-Adjustment Screws
(item #5) and Washers (item #4) to
attach the Anamorphic Lens
assembly to the front of the
projector. (Do not fully tighten the
screws yet.)
Adjusting the Lens Height (Y):
1. Project a white field on the screen.
2. Ensure that the four Height (Y) Adjustment Screws are loose enough to allow vertical
movement of the lens assembly.
3. Slowly move the anamorphic lens into place so that there are no shadows on the top
or bottom of the screen:
1 Anamorphic Lens
38 Runco RS-1100 Series Owner's Operating Manual
2 Mounting Bracket (2x)
3 Pitch Adjustment Screw,
4-40 x 5/16" (4x)
4 Washer (4x)
5 Y-Adjustment Screw,
Phillips Pan-Head,
6-32 x 3/8" (4x)
6 Fender Washer (4x)