Runco RS-1100 CineWide Owner's Operating Manual page 75

Store Settings: For each input, the RS-1100 lets you store image quality settings as
presets that you can recall at a later time. You can create up to three presets per input
and resolution.
When you change a setting, save the change to a preset
Note
afterwards. Otherwise, the change will be lost when a different
input is selected. (Most settings are saved for each input and
resolution separately.)
To store image quality settings to a preset:
1. Select Picture Adjust from the ISF Calibration menu.
2. Select Color Temperature from the Picture Adjust menu.
3. Use the or button to select the "Custom 1" or "Custom 2" color temperature.
Make a note of your selection.
4. Press EXIT.
5. Adjust brightness and contrast as described in the Picture Adjustment section
(page 46). Exit the Picture Adjust menu when finished.
6. Select White Balance from the ISF Calibration menu. Adjust the grayscale as required
(refer to White Balance on page 55).
7. From the White Balance menu, select "Store Custom 1" or "Store Custom 2"
(depending on your selection in Step 3) and press ENTER.
8. From the ISF Calibration menu, select Store Settings and choose the "Memory 1,"
"ISF Night" or "ISF Day" preset to store your settings.
9. Repeat Steps 1 through 8 for the other two presets.
The first time you perform this procedure, store the current white
Tip
balance settings in both the "Custom 1" and "Custom 2" color
temperatures. This will give you a convenient starting point for
Custom 2, should you wish to use it for the other two presets.
To recall stored custom image quality settings, select Restore Image Settings from the
Adjustment menu (refer to Picture Adjustment on page 46) and choose "Memory 1,"
"ISF Night" or "ISF Day." Or, simply use the corresponding buttons on the remote control.
Splash Screen Timer: Use the
controls how long the startup (ISF and Runco logo) image stays on-screen after you turn
on the projector. Select from 5 to 60 seconds, in 1-second increments. When finished,
press EXIT.
ISF Enable: Use ISF Enable to control the display of the ISF logo on the RS-1100 splash
screen upon power-up.
Return to User OSD: To exit the ISF Calibration menu, use the up- or down-arrow keys
to highlight Return to User OSD and press ENTER.
To return to the ISF Calibration menu, select it from the Main Menu, press ENTER twice,
then press MENU on the remote control. (You do not need to re-enter the passcode.)
Runco RS-1100 Series Owner's Operating Manual
or button to set the Splash Screen Timer. This timer
63
Operation