Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper
clip, into the reset opening on the side of the scanner.
Then gently press the reset button inside the open-
ing.
Note: If the scanner still does not work properly, you might
need to initialize the scanner (see "Initializing the Scan-
ner").
Initializing the Scanner
Important: This procedure clears all information you
stored in the scanner's memory. Initialize the scanner only
when you are sure the scanner is not working properly.
1. Turn off the scanner, then turn it on again.
2. Hold down TUNE/CLR.
3. While holding down TUNE/CLR, insert a pointed ob-
ject (such as a straightened paper clip) into the reset
opening on the side of the scanner, then gently press
the reset button inside the opening. The display should
turn off.
4. When the display turns on again, release TUNE/CLR.
Note: You must release the reset button before releasing
TUNE/CLR; otherwise the memory might not clear.
Page 23
23
2003/03/11, 15:46