HighPoint RocketRAID 35 User Manual page 15

Connectors A1-A4 provides LED support for Drive Activity, while connectors F1-F4
indicates Drive Failure.
ACT LED and Fail LED have 5 pins while we just explain 4 pin's function.
J4
This jumper is the SAF-TE interface port (for disk enclosures/chassis)
SAF-TE jumper has 4 pins while we just explain 3 pin's function.
BEEP1 -(alarm/speaker)
the speaker emits and audible alarm in the case of disk/array failure.
J17
This jumper can be used to enable or disable the card's alarm (BEEP1). The alarm is
enabled by default (the jumper is attached). To disable the alarm, remove the jumper
J18 (BBU connector)
Connector for battery backup unit (optional part).
Ethernet Port
Ethernet port (U32) for Out of Band Management, support Net Time Protocol.
Congratulations
15