Timed Cooking - DCS WO-227SS Technical Service Manual

Ope rating Inst ructions
3) About 5 seconds after inserting the probe's plug into
the oven receptacle the flashing word Probe
will show in the display along with rapid beeping.
Press the probe key and enter a probe cooking
temperature between 100
number keys.
4) The display will show the actual probe sensor
temperature of the food.
5) About 5 seconds after entering the probe cooking
temperature the words CONV, BAKE and
ROAST will flash along with rapid beeping. The
control is prompting you to enter a cooking mode,
so select the mode you wish to use; upper BAKE,
CONV BAKE or CONV ROAST.
6) Next enter the temperature at which you want the oven to cook. Do not confuse this with the
internal food temperature (the probe temperature) you set earlier. This will be the temperature of
the oven to actually cook the food. Use the number keys to enter a temperature setting from
100 0 to 550 0 .
7) The oven will heat until it reaches the probe temperature. The actual probe temperature shows in
the display. When the probe set temperature is reached, END will show in the display and the oven
will chime 4 times, the actual probe temperature will flash and the oven will automatically turn off.
The oven will chime once every minute for the next 10 minutes. As the food cools the flashing
probe temperature will show the actual food temperature.
8) Be careful not to burn yourself when removing the food probe plug from the oven receptacle.
Once removed the probe temperature digits will go blank.
9) Wash the stainless steel end of the food probe in hot soapy water but DO NOT get the plug end
of the probe wet. When not in use store in a dry place. It is not recommended to leave the probe
in the oven when not in use.
WARNING: Do not leave the food probe in the oven during the self cleaning as the probe will be
destroyed.
TO USE THE TIMED COOKING
You can set the cooking time for the following modes: Convection Bake, Bake, or Convection Roast.
Cook time will automatically shut off the oven at the specified time and then will chime to signal it is
done. Only one oven at a time can be timed. First set the oven to one of the above mentioned
cooking modes (as described in that section page 27).
0 to 200 0 F using the
30
Location
for the
plug end
of food
probe here.
Insert the food probe