Table of Contents
Advertisement
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Attention:
During normal operation, each power-supply bay must contain either a
power supply or power-supply filler for proper cooling.
To install an ac power supply, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 35.
2. Remove the power-supply filler panel from the empty power-supply bay by
pinching the side clip and pulling the power-supply filler panel from the bay.
Save the power-supply filler panel in case you remove the power supply at a
later time.
Important: During normal operation, each power-supply bay must contain
either a power supply or power-supply filler panel for proper cooling.
3. Slide the ac power supply into the bay until the retention latch clicks into place.
4. Connect the power cord for the new ac power supply to the power-cord
connector on the power supply.
The following illustration shows the ac power-supply connectors on the rear of
the server.
5. Route the power cord through the cable retainer clip so that it does not
accidentally become disconnected.
Chapter 2. Installing optional devices
85
Hide quick links:
Advertisement
Table of Contents
