Rear View - IBM x3630 M4 Type 7158 Installation And User Manual

v Remind button: This button places the system-error LED on the front
v Reset button: Press this button to reset the server and run the power-on
For further information on the light path diagnostics panel, see the Problem
Determination and Service Guide.

Rear view

The following shows the connectors on the rear of the server. The server
configuration may be of the following two:
Illustration when no rear hard disk drive is installed in server. The PCI riser card
assembly for this server configuration is 2U.
information panel into Remind mode. In Remind mode, the system-error LED
flashes every 2 seconds until the problem is corrected, the system is restarted, or
a new problem occurs.
By placing the system-error LED indicator in Remind mode, you acknowledge
that you are aware of the last failure but will not take immediate action to correct
the problem. The remind function is controlled by the IMM2.
self-test (POST). You might have to use a pen or the end of a straightened paper
clip to press the button.
Chapter 1. The System x3630 M4 Type 7158 server
17