Table of Contents
Advertisement
3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. On the next screen, select Network Configuration.
6. Find the IP address and write it down.
7. Exit from the Setup utility.
Logging on to the web interface
To log onto the web interface to use the remote presence functions, complete the
following steps:
1. Open a web browser on a computer that connects to the server and in the
2. On the Login page, type the user name and password. If you are using the
3. On the Welcome page, type a timeout value (in minutes) in the field that is
4. Click Continue to start the session. The System Health page provides a quick
Using the embedded hypervisor
The VMware ESXi embedded hypervisor is available on server models that come
with an installed USB embedded hypervisor flash device. The USB flash device
comes installed in the USB connector on the system board. Hypervisor is
virtualization software that enables multiple operating systems to run on a host
system at the same time. The USB flash device is required to activate the
hypervisor functions.
To start using the embedded hypervisor functions, you must add the USB flash
device to the boot order in the Setup utility.
To add the USB flash device to the boot order, complete the following steps:
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1.
3. From the Setup utility main menu, select Boot Manager.
4. Select Add Boot Option; then, select Embedded Hypervisor. Press Enter, and
5. Select Change Boot Order and then select Commit Changes; then, press
6. Select Save Settings and then select Exit Setup.
108
System x3630 M4 Type 7158: Installation and User's Guide
address or URL field, type the IP address or host name of the IMM2 to which
you want to connect.
Note: The IMM2 defaults to DHCP. If a DHCP host is not available, the IMM2
assigns a static IP address of 192.168.70.125.
IMM2 for the first time, you can obtain the user name and password from your
system administrator. All login attempts are documented in the event log.
Note: The IMM2 is set initially with a user name of USERID and password of
PASSW0RD (passw0rd with a zero, not the letter O). You have read/write
access. You must change the default password the first time you log on.
provided. The IMM2 will log you off of the web interface if your browser is
inactive for the number of minutes that you entered for the timeout value.
view of the system status.
Note: Approximately 5 to 10 seconds after the server is connected to power,
the power-control button becomes active.
then select Esc.
Enter.
Hide quick links:
Advertisement
Table of Contents
