Connecting The Cables; Updating The Server Configuration - IBM System x3755 M3 7164 Installation And User Manual

2. Press the release latches on the top-cover fan door to lock it in place.
3. If necessary, reconnect the power cords and all external cables, and then turn
4. Slide the server into the rack.

Connecting the cables

Notes:
1. Be sure to turn off the server before you connect any cables to or disconnect
2. For additional cabling instructions, see the documentation that comes with the
The following illustration shows the locations of the input and output connectors on
the rear of the server.

Updating the server configuration

When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup utility
starts automatically so that you can save the new configuration settings. For more
information, see Chapter 3, "Configuring the server," on page 75.
72
IBM System x3755 M3 Type 7164: Installation and User's Guide
Latch
on the server.
any cables from the server.
optional devices. It might be easier for you to route any cables before you install
certain optional devices.
Power
connector
AC
DC
!
Gigabit
-
Ethernet 1 4
connectors
System
serial
Video
USB 3 USB 4
connector connector
Latch
System
management
Ethernet