IBM System x3755 M3 7164 Installation And User Manual page 59

v Avoid touching the components and gold-edge connectors on the adapter.
v If you have not changed the default startup sequence, the server starts the
devices in the following order: DVD drive, USB-attached diskette drive, hard disk
drive 0, and network devices.
Note: To change the startup sequence, start the Setup utility and select Start
Options from the main menu. See "Using the Setup utility" on page 76 for details
about using the Setup utility.
v The expansion slots in the PCI riser cards accommodate the various form factors
of the non-hot-plug adapters as follows:
– Expansion slot 1: Full-height, full-length
– Expansion slots 2, 3, and 4: Low-profile, half-length
v You must install a ServeRAID adapter in expansion slot 4 on the PCI riser-card
assembly.
v If you are installing a ServeRAID adapter with a battery installed on the adapter,
you must install the battery on the remote battery tray.
Attention: Static electricity that is released to internal server components when
the server is powered on might cause the server to halt, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when you handle any server components.
Chapter 2. Installing optional devices
41