IBM System x3755 M3 7164 Installation And User Manual page 65

Pin
c. Press the pins into the rings on the remote battery tray. Make sure the two
retention clips secure the battery and battery carrier on the remote battery
tray.
8. Connect the remote battery cable to the battery carrier.
Attention: To avoid damage to the hardware, be sure to align the black dot
on the cable connector with the black dot on the connector on the interposer
card. Do not force the remote battery cable into the connector.
9. Route the remote battery cable through the cage hole on the chassis. You may
store the excess battery cable in the space between the hard drive cage and
the chassis.
Attention: Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.
ServeRAID
controller battery
Remote battery tray
Chapter 2. Installing optional devices
47