IBM System x3755 M3 7164 Installation And User Manual page 95

Setup utility, the changes are reflected in the system summary; you cannot
change settings directly in the system summary.
– Product Data
Select this choice to view the revision level or issue date of the firmware,
integrated management module II and diagnostics code, and the version and
date.
v System Settings
Select this choice to view or change the server component settings. This choice
is on the full Setup utility menu only.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings. To configure
memory mirroring, select System Settings → Memory, and then select
Memory Mode → Mirroring.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports. You can configure the serial ports, configure remote console
redirection, and enable or disable integrated Ethernet controllers and PCI
slots. If you disable a device, it cannot be configured, and the operating
system will not be able to detect it (this is equivalent to disconnecting the
device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
– Integrated Management Module II (IMM2)
Select this choice to view or change the settings for the integrated
management module II (IMM2).
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
the IMM2.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and the host name;
define the static IMM2 IP address, subnet mask, and gateway address;
specify whether to use the static IP address or have DHCP assign the
IMM2 IP address; and save the network changes.
- Reset IMM to Defaults
Select this choice to view or reset the IMM2 to the default settings.
- Reset IMM
Select this choice to reset the IMM.
Chapter 3. Configuring the server
77