Installing An Optional Tape Drive Enablement Kit And Tape Drive - IBM System x3755 M3 7164 Installation And User Manual

Installing an optional tape drive enablement kit and tape drive

The IBM System x37550 M3 tape drive enablement kit is used to install an optional
tape drive in simple-swap models of the server. See http://www.ibm.com/servers/
eserver/serverproven/compat/us/ for a list of supported optional devices. To order a
tape drive enablement kit, contact your IBM marketing representative or authorized
reseller. The IBM System x3755 M3 tape drive enablement kit is compatible only
with the following tape drive:
v IBM DDS Generation 5 (DDS5) SATA tape drive
The IBM System x3755 M3 tape drive enablement kit contains the following
components:
v One tape drive tray (with attached cable)
v Bezel(s)
Note: The optional tape drive is supported only on simple-swap models of the
server.
To install an optional tape drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
on page 28.
2. Turn off the server and peripheral devices, and disconnect the power cord and
all external cables.
3. If the tape drive comes with a metal spacer attached, remove the spacer
before you install the tape drive on the tray.
4. Prepare the drive according to the instructions that come with the drive, setting
any switches or jumpers.
5. Install the drive tray on the new tape drive as shown and tighten the four
screws to secure the tape drive to the bottom tray.
6. Align the tabs on the tape drive bezel with the holes on the tape drive and
insert the tabs until they snap into place.
Chapter 2. Installing optional devices
57