IBM System x3755 M3 7164 Installation And User Manual page 62

8. Route the signal cables and connect the signal cables to the ServeRAID
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 68.
Notes:
1. When you restart the server for the first time after you install a ServeRAID
2. When you restart the server, you are given the opportunity to import the existing
3. Before you install a UEFI operating system on a server with a ServeRAID
44
IBM System x3755 M3 Type 7164: Installation and User's Guide
b. Align the ServeRAID controller with expansion slot 4 on the PCI riser-card
assembly and the guide on the retention tab.
c. Firmly press the ServeRAID controller into the connector. Make sure that the
retention clip securely engages the bracket on the ServeRAID controller.
controller (see "Internal cable routing and connectors" on page 31).
controller with a battery, the monitor screen remains blank while the controller
initializes the battery. This might take a few minutes, after which the startup
process continues. This is a one-time occurrence.
Important: You must allow the initialization process to be completed. If you do
not, the battery pack will not work, and the server might not start.
The battery comes partially charged, at 30% or less of capacity. Run the server
for 4 to 6 hours to fully charge the controller battery. The LED just above the
battery on the controller remains lit until the battery is fully charged.
Until the battery is fully charged, the controller firmware sets the controller
cache to write-through mode; after the battery is fully charged, the controller
firmware re-enables write-back mode.
RAID configuration to the new ServeRAID controller.
controller, you must select UEFI driver for Launch storage OpROM in the
Setup utility (see "Typical operating-system installation" on page 82).